Sheet 07 · Mobile
Mobile service: the shop drives to you — with three honest limits
Most glass work on this sheet is legitimately mobile in North County: the van carries the pane, the urethane, the setting tools, and the calibration kit for dynamic work. What follows is what a good mobile job looks like, and where the format genuinely runs out.
- Booking by VIN. The glass is verified and ordered from your VIN and a photo of the damage and the camera area. Wrong-glass arrivals are a booking failure, not bad luck.
- Site needs. Roughly a car length of flat, workable space around the vehicle, access to the interior, and shelter from rain. Power is on the van. A sloped driveway is workable for glass; it is not workable for static calibration.
- The work. Same sequence as in-shop: cut-out, prep, bead, set. Then the safe drive-away clock runs at your address — plan to leave the car sitting for the urethane's stated time, commonly 30 minutes to several hours by product and weather.
- Calibration. Dynamic calibration finishes with a road drive on marked roads — SR-78 and I-15 frontage roads serve well. Static-only vehicles get routed to a bay, and the operator should say so at booking, not at your curb.
The three limits, stated before you book
- Weather. Rain during a set contaminates the bond; extreme cold slows urethane cure and stretches drive-away time. A mobile operator who works through a downpour is not doing you a favour.
- Tint. Film needs dust control. Some operators tint mobile with canopies and still warrant it; many will not, and their refusal is a quality signal, not laziness.
- Static ADAS. Level floor, target distance, even light. If your model needs it, the honest answer is a bay visit bundled into the same job.
Ready when you are: the request page explains exactly what happens to your details, and the service area page draws the map.